Power Saver 20k watts SAVES UP TO 40% OF ELECTRICAL BILL (PROVEN) For ONLY 1.5k EACH POWERSAVER uses a specially designed capacitor that stabilize the flow of electricity. It reduces the spikes from supplied power thus protecting equipments against surges. POWERSAVER improves the power factor of your electricity and reduces your electricity bill by on average 20%-40%, max for motorized appliance. 100% Brand new The actual effective electric power consumption in the industry and household is only 60%, and the rest is wasted, but the user will have no choice to pay for all these consumption. This is because during the power transportation, the power supplier will use higher voltage to avoid the power wastage and lower voltage of user at the peak hours, so the actual voltage used is much higher than the rated power of the appliance. But the excessive voltage cannot make the appliance run efficiently, on the contrary, it will result in increased power consumption & expenditure as well as shortened lifespan, this is the key reason to cause overheating of the appliance. Most suitable for inductive and capacitive appliances, such as Air-Conditioners, Refregirators, Washing Machines, Stereos, Computer, Flourescent Lamps, Electric Fans, Televisions, etc.. Helps: Saves Electricity up to 20%-40% Stabilize voltage and prevent the voltage instability, prolong lifespan of your appliances. Improve electrical efficiency and power factor Single phase, easy to use, no wiring and maintenance required Just plug the electricity saver in any 110-250v electrical outlet in your home or office Suitable for use in Homes, Computer shops, restaurant, office, etc. specially for the following equipments: Air-Condition, Washing Machine, Refrigerator, TC, PC, Water Pumps, Florescent Light(Not CFL). Dagdag kaalaman Power factor From Wikipedia, the free encyclopedia http://en.wikipedia.org/wiki/Power_factor The power factor of an AC electric power system is defined as the ratio of the real power flowing to the load to the apparent power and is a number between 0 and 1 (frequently expressed as a percentage, e.g. 0.5 pf = 50% pf). Real power is the capacity of the circuit for performing work in a particular time. Apparent power is the product of the current and voltage of the circuit. Due to energy stored in the load and returned to the source, or due to a non-linear load that distorts the wave shape of the current drawn from the source, the apparent power can be greater than the real power. In an electric power system, a load with low power factor draws more current than a load with a high power factor for the same amount of useful power transferred. The higher currents increase the energy lost in the distribution system, and require larger wires and other equipment. Because of the costs of larger equipment and wasted energy, electrical utilities will usually charge a higher cost to industrial or commercial customers where there is a low power factor. Linear loads with low power factor (such as induction motors) can be corrected with a passive network of capacitors or inductors. Non-linear loads, such as rectifiers, distort the current drawn from the system. In such cases, active power factor correction is used to counteract the distortion and raise power factor. The devices for correction of power factor may be at a central substation, or spread out over a distribution system, or built into power-consuming equipment. DAGDAG paliwanag ulet Ang power saver po ay nakakapagpatipid sa pagpapaimprove ng power factor. Hindi po ito nag gegenerate ng power. ang savings po ay base sa kumbinasyon ng mga load (Power saver rating, at mga appliances na ginagamit sa particular period of time). Kung wala pong load o mas maliit ang load against sa power saver tataas talaga ang kunsumo ng kuryente dahil ang power saver ay magiging load. Kung puro ilaw lang po ang gagamitan ninyo ng power saver hindi siya magiging effective, kasi kung ang paraan po nila para makatipid ng kuryente is using capacitor, ito ay para lang ma-correct ang power factor ng isang electrical system.Kung marami kang motor sa iyong system magiging reactive ang iyong system, thereby using capacitors will corect the system, at makakatipid po kayo ng kuryente using a power saver. Dapat ay nasa tama ang pag gamit nan power saver upang maging effective eto, pag nasa 5k+ ang bills mu sa kuryente dapat ang gamitin mu ay 30k watts na power saver at kapag 5k pababa naman ang bills mu sa kuryente dapat ay 20kwatts ang gamitin na power saver .. For Faster Transaction txt me at 09056273844 Money-back GUARANTEE
